Best Classic Christmas Pudding Recipes

CHRISTMAS PUDDING

Steps:

• The day before you want to steam the pudding: In a large bowl, thoroughly mix the suet, brown sugar, sifted flour, breadcrumbs, allspice, clove, nutmeg, and cinnamon. Gradually mix in the currants, sultanas, raisins, candied peel, and almonds, followed by the apple and citrus zests. In a small bowl, whisk together the rum, barley wine, and stout, and then beat in the eggs. Pour this mixture over the dried fruit and nut mixture. Mix thoroughly. It should be somewhat loose; if it needs a little more liquid, add some stout. Cover the bowl and refrigerate overnight.
• The following day: Butter a 1-pint pudding mold and pack the pudding mixture into it. Cover with a double piece of parchment and a sheet of foil and tie securely with a string across the top to make a handle. Place the pudding mold in a covered steamer set over a saucepan of simmering water, and steam for 8 hours. Check the water level, adding boiling water as needed. When the pudding is finished, let it cool and then remove the papers and foil. Replace with fresh paper and make a new string for easier maneuvering. Set in a cool place away from light (under the bed works well).
• To reheat, set a saucepan with boiling water over medium heat and put a steamer on top. Reduce the heat to a gentle simmer, set the pudding in the steamer, cover, and let steam for 2 1/4 hours. Top up the water a bit if necessary.
• To serve, remove the pudding from the steamer and take off the wrapping. Slide a palette knife around the pudding, and then turn it out onto a warm plate. Garnish with a sprig of holly. To flambe the pudding, warm a ladleful of brandy over direct heat, and when it is hot, carefully light the brandy. Place the flaming ladle over the pudding, but do not pour until at the table. When you do slowly pour it over the pudding, sides and all, watch it flame! Serve with rum sauce if desired.
• This recipe was provided by professional chefs and has been scaled down from a bulk recipe provided by a restaurant. The Food Network Kitchens chefs have not tested this recipe, in the proportions indicated, and therefore, we cannot make any representation as to the results.

AUTHENTIC CHRISTMAS PUDDING (FIGGY PUDDING)

Steps:

• Place the raisins, sultanas, currants, almonds, and candied citrus peel in a bowl. Pour the brandy over and stir to combine the mixture. Cover and let sit overnight to allow the brandy to fully penetrate the fruit.
• The next day, place the breadcrumbs, flour, baking powder, brown sugar, and spices in a bowl and stir to combine.In another bowl add the soaked dried fruit mixture, grated apple, black treacle, suet, lemon and orange zest, and egg. Stir to combine.Add the dry mixture to the fruit mixture and stir to thoroughly combine it. It will be thick and sticky.Generously butter your pudding mold (2 liter/3.5 pints mold) and scoop the batter into the mold, pressing down and smoothing the top.Cut a circle out of parchment paper the same diameter as the top of the pudding mold. Lightly butter the paper and place it, butter side down, on top of the batter. Next tear off two more pieces of parchment paper large enough to cover the to of the pudding mold and partially down the sides of the mold. If your pudding mold is small and the batter comes to the top of it, fold a pleat in the center of the parchment papers to allow room for expansion as the pudding cooks. Trim off excess paper.Secure the paper by folding down the sides and tying securely with a string (to make it easier you can secure it first with a rubber band while you're tying it and then remove the rubber band).Note: If your mold comes with a lid as mine does, I still like to adda layer of parchment paper before securing the lid.Bring a large pot of water to a very low simmer. Place a folded cloth or trivet on the bottom of the pot to prevent the pudding mold from coming in direct contact with the pot in order to prevent scorching.Lower the pudding mold down into the water on top of the folded cloth. The water level should come up to the halfway point of the pudding mold. Cover the pot with the lid.Steam the pudding over very low heat for approximately 8 hours. Check periodically to ensure the water level is still at the halfway point and add more water as needed.The longer the pudding steams the darker in color it will become.
• When the pudding is done steaming, carefully lift out the pudding mold and let it sit for 5 minutes. Then invert the pudding on a plate. Let it sit until the pudding slides out onto the plate. Let the pudding cool completely.To store, remove the parchment paper and wrap the pudding with clean parchment paper followed by aluminum foil. Wrap tightly. Store it in a cool, dark place, preferably a basement. If you do not have a cool, dark environment in your home you can keep it in the fridge but make sure it is tightly wrapped in two layers of plastic wrap and some aluminum foil to prevent it from drying out. Follow these same guidelines along with placing the pudding in a ziplock freezer bag to freeze the pudding. When you're ready to serve the pudding you will need to reheat it either by re-steaming it for 30-60 minutes or until heated through or you can also microwave it in a microwave safe container to keep the moisture in.You can light the pudding on fire just before serving (see blog post section on how to light a pudding) and then serve with Hard Sauce (i.e., brandy butter) or powdered sugar, whipped cream, vanilla custard, ice cream, or lemon sauce.