Best Sticky Ribs With Corn Salad Recipes

STICKY RIBS

Steps:

• Prepare a charcoal grill using the snake method: Stack the unlit charcoals around the perimeter of the grill, about halfway, then light the first few at one end so the snake begins to burn slowly. (This results in a controlled 325 to 350 degrees F heat; see Cook's Note.) Fill a metal loaf pan with about 1 cup water and place it next to the coals for additional moisture.
• Season the ribs liberally with salt and pepper.
• Combine the beer, sugar, soy sauce, ketchup, mustard, vinegar, ginger, crushed red pepper flakes, garlic, a small pinch of salt and about 1/2 teaspoon pepper in a medium saucepan and whisk until smooth. Bring to a simmer over direct heat and cook until reduced by a third, about 30 minutes.
• Place the ribs bone-side down on the grill over indirect heat. Close the grill and cook, brushing the ribs with the glaze every 30 minutes to an hour, until an instant-read thermometer registers 200 degrees F, 3 to 3.5 hours. (Make sure to keep the temperature of the grill between 275 to 350 degrees F.)
• Take the ribs off the grill, wrap in aluminum foil and let rest 10 to 15 minutes. Bring the remaining glaze back to a simmer over direct heat for several minutes. Garnish the ribs with the cilantro and serve with the remaining glaze on the side.
• (Alternatively, you can bake the ribs on a rimmed baking sheet in a 300 degrees F oven for 3 to 3.5 hours.)

EASY GRILLED STICKY RIBS

Steps:

• Preheat the oven to 250 degrees F (120 degrees C).
• Mix salt, sugar, black pepper, paprika, and garlic powder for dry rub together in a small bowl. Set aside.
• Line a large sheet pan with heavy-duty aluminum foil. Place rack of ribs on the prepared pan, bone side down. Poke all over with a sharp knife. Make shallow slits across at an angle, and then repeat the opposite way; this allows the dry rub to penetrate. Coat on both sides with rub; flip back over, ensuring the bone side is down. Wrap tightly with foil.
• Transfer to the center of the preheated oven and bake for 2 hours. Remove from the oven and let cool to room temperature. Refrigerate until cold and firm, at least 2 hours, up to overnight.
• Preheat a charcoal grill until coals are very ashy and hot.
• Remove from the refrigerator, unwrap, and brush off excess fat. Slice between the bones to separate each rib.
• Combine ketchup, brown sugar, soy sauce, vinegar, oil, and cayenne with a spoon in a bowl for glaze.
• Place ribs on the preheated grill and cook for 2 minutes; flip and brush over glaze. Flip and repeat process until ribs are as caramelized as you prefer, about 10 minutes more.
• Remove to a plate and brush over one more application of glaze. Serve.

STICKY RIBS WITH CORN SALAD

Steps:

• Heat the grill. In a large pan of water, simmer the ribs for 15 mins. Drain and pat dry. In a large roasting tin, toss ribs with the sauce, then grill for 8-10 mins, turning halfway, until the ribs are sticky.
• Mix the remaining ingredients in a large bowl with some seasoning.
• Just before serving, shake the tin so the ribs are evenly coated in sauce, then serve a couple of ribs per person with the salad and lime wedges.

STICKY RIBS

Steps:

• Preheat the oven to 300 degrees F.
• Combine the brown sugar, granulated sugar, chili powder, garlic powder, onion powder, paprika, 2 teaspoons salt and a generous amount of freshly ground black pepper in a small bowl (I did 30 grinds).
• Place the ribs on a piece of foil large enough to fold over and seal, then place on a baking sheet. Sprinkle the dry rub all over the top of the meaty side of the ribs. Wrap the foil around the ribs and seal tightly so that no juices can escape during baking. Bake until the meat is tender and can easily be pulled away from the bones with a fork, about 2 hours.
• Heat the BBQ sauce in a small pan over medium heat until warm. Remove the ribs from the oven and open the foil pack. Remove the ribs from the foil and pour any juices that have accumulated into the BBQ sauce and mix to combine. Continue to simmer the sauce until thickened, about 7 minutes.
• Heat a grill or grill pan for cooking at medium-high heat.
• Slice the ribs into 1-bone pieces. Brush all over with the BBQ sauce. Place the ribs on the grill and cook until grill marks appear, a few minutes on each side. Brush with more BBQ sauce and remove from the heat, then serve with the remaining BBQ sauce on the side.

KILLER STICKY RIBS, RUB AND SAUCE

Steps:

• Combine all ingredients for the rub in a plastic bag or tightly lidded container. Be sure there are no clumps of brown sugar and that spices are well distributed and combined. Reserve 2 tablespoons of the rub for the sauce. (If only using enough rub for fewer than 4 racks of ribs, separate amount of rub you will need so as not to contaminate what is left over. You may store additional rub mixture in a sealed container or zip top bag for further use - it works very well on pork chops or chicken.).
• Remove membrane from the underside of ribs. This can be easily done by using a paring knife to loosen one edge of the membrane and then, using paper towel to grab the membrane, pull it off. Rinse off ribs and pat dry with paper towels. Apply remaining rub on both sides of ribs. Wrap the ribs plastic or use an extra large food grade zip top bag. Refrigerate for up to 24 hours or at least 3 hours.
• 30 minutes before being ready to put ribs on grill, remove them from refrigerator and allow them to come closer to room temperature. On a gas grill set flame so that the temperature with the grill lid closed is 200-250°F Place water in a small aluminum pan (I use a loaf pan) on one side of the grill. This will allow a moist heat to penetrate the meat and allow for more moistness. Don't allow the water to evaporate completely. If you can use wood chips to smoke the meat with your grill, this is the time to get the chips smoking.
• Place ribs on the grill bone side down and leave them on the grill for 1½ to 3 hours at this temperature (depending upon how much time you have and how tender you want the meat). I try to turn the ribs about every 30-40 minutes. It will be necessary to turn the ribs at least once. This is actually something that you need to see when it's time to do. Check your ribs periodically to be sure that they are not getting charred and that your grill is not too hot. Depending upon your grill, you may have to turn the ribs more often to avoid hot spots or flame ups. If you haven't already done so, at about the 2 hour point, you'll need to turn the ribs over. Allow them an additional 1 1/2 - 2 hours on the grill depending upon your time schedule. The more time they are done low and slow, the more tender they will become.
• (If you can't or don't want to grill the ribs, heat oven to 250°F Place ribs on a wire rack on top of a jelly roll pan. Place water in the bottom of the pan so that it does not come up to the rack. Use foil to tightly wrap the entire pan. Bake in oven for 3-4 hours.).
• While grilling the ribs, mix all ingredients for the sauce in a heavy-bottomed sauce pan. Add 2 tablespoons of reserved spices and add to the sauce mixture. Bring to a simmer and allow to simmer for 5 minutes. Remove from heat.
• If you prefer, mop the some of the sauce onto the ribs in the last 10 minutes of grilling. Leave the rest of the sauce so that guests can add their own sauce according to their tastes.
• Upon removing ribs from the grill, cut them into smaller sections or individual ribs (usually they're ready to fall apart). Serve immediately to a very happy crowd.