Best Seven Bone Pot Roast In The Pressure Cooker Recipes

EASY PRESSURE COOKER POT ROAST

Steps:

• Heat oil in a pressure cooker over medium-high heat. Brown roast on all sides in the hot oil; season with pepper, seasoned salt, and onion powder.
• Pour in beef broth and Worcestershire sauce, add the quartered onion, and seal the lid. Bring the cooker up to full pressure. Reduce heat to low, maintaining full pressure, and cook for 30 minutes.
• Use the quick-release method to lower the pressure. Mix in carrots and potatoes, seal the lid again, and return the pressure cooker to the heat. Bring the cooker up to full pressure and cook for an additional 15 minutes. Use the quick-release method again and transfer the roast and vegetables to a serving dish.

PRESSURE COOKER POT ROAST

Steps:

• Bring chuck roast to room temperature, then season well with salt and pepper.
• Heat the Instant Pot using the sauté setting. Once hot, add oil, then sear roast on both sides. Set aside.
• Add 1 onion and celery to pot and cook for 2 minutes, until soft and translucent. Then add garlic, thyme, rosemary, and bay leaf - continue cooking for 1 minute.
• Add red wine to deglaze the pot, making sure to scrape up all bits. Let wine simmer for at least 2 minutes.
• Add roast, then add enough broth so that the roast is just barely covered.
• Lock lid and cook for 75 minutes at high pressure. Once time is complete, let pressure naturally release (about 30 minutes).
• Carefully remove roast and set aside to rest.
• Using a fine mesh strainer, pour liquid into separate container, then return to pot. Discard aromatics.
• Add sliced onion, carrots, and potatoes to pot and close lid.
• Lock lid and cook for 4 minutes at high pressure, then quick-release pressure.
• Meanwhile - In a small dish, combine cornstarch and water. Once cook time is complete, open lid, switch to sauté setting, and add cornstarch slurry to pot. Cook until desired consistency is achieved (2-3 minutes).
• Return roast to pot and pull apart meat as much as you like.
• Serve together and enjoy!

PERFECT PRESSURE COOKER POT ROAST

Steps:

• Heat oil in the pressure cooker over medium-high heat with the lid open. Brown the roast on all sides in the hot oil.
• In a small cup or bowl, mix together the Italian salad dressing mix, Ranch dressing mix, and gravy mix. Sprinkle them evenly over the roast. Pour in the beef broth and add the chopped onion.
• Seal and lock pressure cooker, and cook over high heat to build pressure until the indicator sounds (mine whistles). Turn heat down to medium, and cook for 45 minutes. Remove from heat and let stand for 5 minutes. Run under cold water to help release the pressure before unsealing the lid. You can use the juices as an au jus, or thicken with flour or cornstarch to make a yummy gravy.

EASY INSTANT POT POT ROAST (TENDER AND JUICY)

Steps:

• Season all sides of the beef with a generous amount of salt (2 to 3 teaspoons) and then set aside, at room temperature, for one hour.
• Meanwhile, make a spice mixture by stirring the onion powder, garlic powder, and black pepper until blended.
• Prepare the vegetables. Peel and cut the onion into large chunks. Peel the carrots and remove the ends. Slice the carrots and celery into thick long sticks. Smash garlic cloves with the flat side of a knife and peel away the skins.
• After an hour, use paper towels to pat the beef dry on all sides (this helps the meat brown), and then rub the beef on all sides with the spice mixture. The beef should be well seasoned on all sides with the spices. (You might have some leftover.)
• Add oil to the bottom of a 6-quart Instant Pot (or electric pressure cooker). Select the "Sauté" setting and choose high heat. When the oil is hot and shimmering, add the beef. Cook until well-browned on all sides, about four minutes per side. Transfer the browned beef to a plate.
• Add the onion, carrots, celery, and garlic cloves to the pot and cook, stirring occasionally until they start to sweat and lightly brown around the edges, about 6 minutes. Transfer the vegetables to a plate.
• Pour in the broth, bouillon, and apple cider vinegar, and then use a wooden spoon to scrape up any browned bits stuck to the bottom of the pot (not doing this may result in an error while cooking at pressure).
• Turn the 'saute' function off. Place the beef back into the pot and scatter the onions, carrots, celery, and garlic around the beef. Add the rosemary, thyme, bay leaf, and baby potatoes (optional). It is okay if the liquid in the pot does not completely cover the beef and vegetables.
• Select the "Pressure Cook" or "Manual" function and cook on high pressure for 60 minutes. Note that the timer will not start until there is enough pressure inside the pot, so the timer may not start for a few minutes. If your roast is not 3 pounds, you will need to adjust the cook time. As a general rule, when cooking beef roasts in a pressure cooker, assume 20 minutes of cook time for every pound of meat.
• When the cooking time is up, do not immediately open the lid and instead let the pressure naturally release for 10 minutes. After 10 minutes, release the remaining pressure by using the quick-release button (be careful to keep your hands and face away from the venting steam).
• Taste the liquid and adjust with additional salt and pepper. Transfer the beef roast to a cutting board and gently shred to your desired size and place onto a serving platter.
• If you added them, remove the potatoes and gently mash them for serving or serve whole on the platter alongside the pot roast.
• The remaining vegetables will be very soft, if you enjoy them this way, transfer them to the serving platter. If you do not like vegetables to be so soft, you can discard them. They have already done a wonderful job of flavoring the broth and roast.
• Serve drizzled with some of the liquid left in the pot. (Or make a quick gravy.)
• To make a quick gravy with the liquid left in the pot, use a strainer to remove any bits of vegetables and herbs from the liquid. Select the "Sauté" setting and choose high heat then bring the liquid to a boil and cook until it reduces by a quarter, 1 to 2 minutes.
• Meanwhile, whisk the cornstarch and water together. When the liquid has reduced, slowly whisk in the cornstarch mixture. Continue to boil until the gravy thickens. Turn off the pressure cooker, and then season the gravy to taste with additional salt, pepper, or spices. (For a creamier gravy, add a small splash of cream.)

PRESSURE-COOKER MELT-IN-YOUR-MOUTH CHUCK ROAST

Steps:

• In a bowl, mix first 10 ingredients. Place onion, green pepper and celery in a 6-qt. electric pressure cooker; place roast over top. Pour tomato mixture over roast. Lock lid; adjust to pressure-cook on high for 35 minutes. Allow pressure to naturally release for 10 minutes, then quick-release any remaining pressure. , Remove roast and strain cooking juices, reserving vegetables; keep roast and vegetables warm. Skim fat from juices. Return juices to the pressure cooker. Select saute setting and adjust for low heat; bring juices to a boil. In a small bowl, mix cornstarch and water until smooth; stir into cooking juices. Cook and stir until sauce is thickened, 1-2 minutes. , Serve roast and vegetables with gravy.

PRESSURE COOKER POT ROAST

Steps:

• Season the beef generously all over with about 1 tablespoon salt. Using the sauté setting, warm the oil in a 6- to 8-quart electric pressure cooker. Add one chunk of the beef and sear one side until deeply browned, about 5 minutes. Remove the first chunk and repeat with the remaining chunk, searing one side. (You can brown more than one side of each chunk, but one side is enough to build flavor without spending too much time on this step.) If the pressure cooker gives you a "hot" error, simply turn it off and use residual heat to cook. When it cools, turn the sauté setting back on.
• Add the pearl onions and garlic; season with salt and pepper. Cook, stirring, until the garlic is softened, about 2 minutes. Pour in the wine, vinegar and 1/2 cup water; season generously with black pepper and lightly with salt. Using a metal or wooden spoon or spatula, scrape up all the browned bits on the bottom of the pot. Turn off the sauté setting. Add the herbs and nestle the beef into the liquid. Cook on high pressure for 1 hour.
• Make the pickled onions, if desired: Bring the vinegar and sugar to a boil in a small saucepan. Add the pearl onions and a generous pinch of salt and cook, stirring, to dissolve the sugar and warm the onions through, about 1 minute. Remove the mixture from heat and set aside at room temperature to pickle for at least 1 hour. (You can make the pickled onions up to 5 days ahead; store them in a sealed container in the refrigerator.)
• Allow the pressure to reduce naturally for 10 minutes, then release the remaining pressure manually. Add the vegetables to the pot, tucking them below the liquid. Cook on high pressure until the beef and vegetables are both tender, an additional 4 minutes. Quick-release the pressure by twisting the pressure knob to vent, then open the lid. Using tongs and a slotted spoon, remove the beef and vegetables to a serving platter. Break the beef into large chunks to serve. At this point, you can simply drizzle some cooking liquid over the top of the beef and vegetables, and top with the drained, pickled pearl onions to serve. Discard the remaining cooking liquid or strain it, refrigerate it, discard the layer of fat and freeze the remaining liquid as beef stock.
• If you'd prefer a thicker gravy, strain the cooking liquid and return it to the pot. Using the sauté function, bring it to a boil. Meanwhile, combine the butter and flour in a small bowl and knead it together with your fingers until it is uniform, almost like a dough. Once the liquid is boiling, drop the butter-flour mixture into the pot, whisking well to combine. Let it bubble until it is lightly thickened, about 5 minutes, then drizzle some gravy over the pot roast and vegetables, and top with drained, pickled onions. Serve extra gravy on the side.