Best Fall Off The Bone Beer Can Chicken Recipes

BEER CAN CHICKEN

Steps:

• Prepare the grill: If you are using charcoal, put the coals on one side of the grill, leaving another side free of coals. If you are using a gas grill, fire up only half of the burners.
• Season the chicken and rub it with oil: Remove neck and giblets from cavity of chicken, if the chicken came with them. Mix the salt, pepper, and thyme in a little bowl, and rub it all over the chicken. Rub the chicken all over with olive oil.
• Lower chicken onto half-filled beer can: Make sure the beer can is open, and only half-filled with beer (drink the other half!) If you want, you can put a sprig of thyme (or another herb like rosemary or sage) in the beer can. Lower the chicken on to the open can, so that the chicken is sitting upright, with the can in its cavity.
• Carefully transfer the chicken to a tray or pan: I say "carefully" because the beer can, and the beer inside of it, is quite hot. One way to do this is to slide a metal spatula under the bottom of the beer can. Use tongs to hold the top of the chicken. Lift the chicken, beer can still inside, and move it to a tray. Let the chicken rest for 10 minutes. Carefully lift the chicken off of the can. If it gets stuck, lay the chicken on its side, and pull out the can with tongs.

FALL-OFF-THE-BONE BEER CAN CHICKEN

Steps:

• Preheat oven to 350 degrees F (175 degrees C).
• Spoon garlic powder into beer in the can. Prop the chicken, butt-side down, onto the beer can so the can goes into the cavity. Place the chicken, with the can as a stand, into a large oven-proof skillet.
• Melt butter in a small saucepan over medium-high heat; add garlic and cook until butter starts bubbling, about 2 minutes. Remove garlic and discard.
• Inject chicken with the garlic-infused butter using a baster or injector until all areas are injected.
• Mix brown sugar, paprika, black pepper, and salt in a small bowl. Coat chicken with brown sugar mixture.
• Bake in the preheated oven until no longer pink at the bone and the juices run clear, about 2 hours. An instant-read thermometer inserted into the thickest part of the thigh, near the bone should read 165 degrees F (74 degrees C).

BEER CAN CHICKEN

Steps:

• Preheat an outdoor grill for medium-high heat, about 375 degrees F (190 degrees C). Mix the brown sugar, chili powder, paprika, dry mustard, salt, and ground black pepper in a small bowl. Place the half-full can of beer in the center of a plate.
• Rinse chicken under cold running water. Discard giblets and neck from chicken; drain and pat dry. Fit whole chicken over the can of beer with the legs on the bottom; keep upright. Sprinkle 1 teaspoon of the seasoning mix into the top cavity of the chicken. The beer may foam up when the seasonings fall inside the can. Rub the remaining seasoning mix over the entire surface of the chicken.
• Place the chicken, standing on the can, directly on the preheated grill. Close the lid and barbeque the chicken until no longer pink at the bone and the juices run clear, about 1 hour 15 minutes. An instant-read thermometer inserted into the thickest part of the thigh, near the bone should read 180 degrees F (82 degrees C). Remove the chicken from the grill and discard the beer can. Cover the chicken with a doubled sheet of aluminum foil, and allow to rest in a warm area for 10 minutes before slicing.

FALL-OFF-THE-BONE CHICKEN

Steps:

• Combine the sugar, paprika, garlic powder, 1 tablespoon salt and 1/2 teaspoon black pepper in a large bowl. Toss the chicken in the spice mixture until coated. Arrange the chicken in a single layer in a flameproof 9-by-13-inch baking dish. Cover with foil and refrigerate for at least 4 hours and up to overnight.
• Preheat the oven to 300 degrees F.
• Bake until the chicken is super moist and falling off the bone, about 2 hours. Remove the baking dish from the oven and remove the foil. Use a spoon or ladle to remove as much liquid from the dish as possible and reserve. Turn the oven to broil.
• Broil the chicken until the skin is golden brown and slightly crisp, about 5 minutes. Sprinkle the chicken with the chives and serve with the reserved pan juices.

BEER CAN CHICKEN

Steps:

• Remove and discard the fat just inside the body cavities of the chicken. Remove the package of giblets and set aside for another use. Rinse the chicken inside and out, under cold running water, then drain and blot dry inside and out, with paper towels. Sprinkle 1 tablespoon of the rub inside the body and neck cavities, then rub another 1 tablespoon all over the skin of the bird. If you wish, rub another 1/2 tablespoon of the mixture between the flesh and skin. Cover and refrigerate the chicken while you preheat the grill.
• Set up the grill for indirect grilling, placing a drip pan in the center. If using a charcoal grill, preheat it to medium. If using a gas grill, place all the wood chips in the smoker box and preheat to high; then when smoke appears, lower the heat to medium.
• Pop the tab on the beer can. Using a 'church key'-style can opener, make 6 or 7 holes in the top of the can. Pour out the top inch of beer, then spoon the remaining dry rub through the holes into the beer. Holding the chicken upright, with the opening of the body cavity down, insert the beer can into the cavity.
• When ready to cook, if using charcoal, toss 1/2 the wood chips on the coals. Oil the grill grate. Stand the chicken up in the center of the hot grate, over the drip pan. Spread out the legs to form a sort of tripod, to support the bird.
• Cover the grill and cook the chicken until fall-off-the-bone tender, 2 hours. If using charcoal, add 10 to 12 fresh coals per side and the remaining wood chips after 1 hour.
• Using tongs, lift the bird to a cutting board or platter, holding a large metal spatula underneath the beer can for support. (Have the board or platter right next to the bird to make the move shorter. Be careful not to spill hot beer on yourself.) Let stand for 5 minutes before carving meat off the upright carcass. (Toss the beer can out along with the carcass.)