Best Espresso Bean Shortbread Recipes

ESPRESSO SHORTBREAD

Steps:

• Preheat the oven to 350 degrees F.
• First, cream the butter and sugar together until it's light and fluffy. Add vanilla extract and mix for about 30 seconds. Then add the flour and espresso powder and mix until dough is smooth, about 1 minute.
• Spray a 9"x9" pan with cooking spray and scatter the ground espresso across the bottom of the pan. Gently press dough evenly into the espresso covered pan. Place pan into the top part of the oven and bake until shortbread is set, about 17 to 20 minutes. Remove from oven and let cool about 15 minutes.
• Using a sharp knife, score the top of the still warm short bread. Cut in 2" squares(or how you like). Run a butter knife around the edge of the pan and invert onto a cutting board. Give a sharp rap and the shortbread will release from the pan. Let it cool aobut 10 more minutes and slice along the scored lines. Enjoy!

ESPRESSO SHORTBREAD BARS

Steps:

• Preheat oven to 300. Line 9x13 baking pan with parchment paper.
• For the BARS: In a large bowl beat butter and sugar at med speed until fluffy and very pale. Beat in vanilla and salt. In a small bowl, combine flour and espresso powder. Add dry ingredients to large bowl in 3rds, scraping and beating until just combined.
• Firmly press dough into the baking pan in an even layer using plastic wrap on top with a flat utensil to spread to entire pan. Toss plastic.
• Bake about 40 minutes or until very lightly browned and firm but not solid to the touch. Do not over cook. Cool pan on rack about 10 minutes.
• Cut bars into 5 strips by 8 strips. (40 bars) Cool completely.
• For the GLAZE: In a small saucepan, combine butter, brown sugar, espresso, corn syrup and salt. Boil over moderate heat, swirling the pan, until slightly thickened (1-2 minutes). Remove from heat. When bubbling subsides, pour quickly over shortbread, spreading in an even layer with a spatula. Using a lightly oiled knife, score the glaze without dragging, along cuts. Press an espresso bean in the center of each bar. Cool slightly then separate bars and transfer to a plate.