Best Chocolate Covered Oreos Recipes

WHITE-CHOCOLATE COVERED OREOS

Steps:

• Melt white chocolate (In microwave, over stove, etc.).
• The time it takes to melt it varies, depending on the heat of the microwave or stove.
• Heat it up for a minute or two, check on it, and heat it again.
• Dip each oreo in white chocolate, then lay out on a paper towel (You can really use anything, tinfoil, baking sheet, etc.).
• Sprinkle with sprinkles!
• Let cool for about 30 minutes.
• Enjoy!

ST. PATRICK'S DAY CHOCOLATE-COVERED OREOS®

Steps:

• Place green confectioners' coating in the top of a double boiler over simmering water. Stir constantly, scraping down the sides with a rubber spatula to avoid scorching, until melted, about 5 minutes. Remove from heat.
• Dip cookies, one at a time, 2/3 of the way into the melted candy, then place on wax paper.
• Sprinkle the nonpareils on top of the wet candy before the candy coating dries. You might need to work in batches so you can add the sprinkles before the first cookies have dried. Allow the candy coating to dry and harden before serving.

CHOCOLATE COVERED OREOS RECIPE - (4.3/5)

Steps:

• Step 1: Melt your chocolate candy coating in the microwave. Put a few squares of chocolate in a glass or ceramic bowl and place in the microwave on 50% power for about 1 minute. Take out, stir and put back in at 50% power for 15 seconds. Keep repeating until the chocolate is melted but be sure not to overheat - it will burn the chocolate and that is a definite no-no. We must not burn the chocolate! Never, ever waste chocolate. Step 2: Spoon some melted chocolate into your Oreo mold about a third of the way full. Place a Double Stuff Oreo cookie into the chocolate and press down until the top of the cookie is level and just a bit lower that the top of the mold. Spoon more chocolate over the cookie until it is covered with chocolate. Tap the mold against your countertop to make sure all air bubbles are removed and that the chocolate has gotten down on the sides of the cookie. Next, take a offset spatula or some other flat and straight tool like the back of a large knife and scrape across to level the chocolate out. Step 3: After filling each of the cookie mold cavities with an Oreo and chocolate and scraping across the top to level off each cookie, place the mold in the refrigerator for about 10 minutes or until the chocolate has firmed up. Turn the mold over and pop out each chocolate covered cookie. You'll be amazed how perfectly formed they are and how easy it was to make them. Step 4: Next, take a sharp knife and run around the edge of the cookie to cut off any excess chocolate. Smooth all around the bottom edge with your fingers. (Uhh.... I think I forgot to tell you to wash your hands, but I'm hoping you did that way before Step 1.) Step 5: Take your chocolate transfer sheet and cut off only the portion that you will be needing. My mold had 6 cavities so I cut a piece wide enough to cut out six circles that would fit on top of the chocolate covered Oreo cookie Step 6: Place the transfer sheet on top of piece of wax paper (I sprayed the bottom side of the wax paper with Pam cooking spray so that it wouldn't shift around the countertop). Next, pour out some of your melted chocolate on top of the chocolate transfer sheet. Step 7: Carefully spread the chocolate to cover all of the transfer pattern with an offset spatula or the back side of a large knife. Spread the chocolate until you have a thin, even layer. (Note: Be careful not to shift the bottom layer of chocolate against the design too much -- I made the mistake of doing that and it broke up the design pattern a little.) Allow the chocolate to set for 5 to 7 minutes or until it's no longer glossy but not completely firm and brittle. At this point, you can cut circles of the chocolate patterns to fit on top of your chocolate covered Oreos. Use a circle cookie cutter just a little smaller than the diameter of your Oreo and press into the thin layer of firmed chocolate. Press and turn the cookie cutter until you have punched out a circle of the chocolate transfer sheet. Step 8: Put a small dab of melted chocolate on the back side of your patterned chocolate and apply the circle to the top of your chocolate covered Oreo. Step 9: Repeat the whole process until you've made a plate full of beautiful cookies. It's really that easy! I definitely recommend buying more than one Oreo cookie mold. Mine came with 6 cavities and it would have been much quicker and more efficient to have 12. But all in all, I was fascinated with the results and with all of the choices of chocolate transfers, it's truly something you could make for all kinds of parties

CHOCOLATE-COVERED OREOS®

Steps:

• Place milk chocolate chips and shortening in the top of a double boiler over simmering water. Stir frequently, scraping down the sides with a rubber spatula to avoid scorching, until chocolate is melted, about 5 minutes.
• Meanwhile, line a baking sheet with parchment paper.
• Drop one Oreo® into the chocolate, making sure it is covered completely. Remove the cookie using a knife, picking it up by the bottom. Lightly shake or tap the knife so that excess chocolate can be removed and place on the prepared baking sheet. Repeat with remaining cookies.
• Let cookies dry completely, about 1 hour.
• Drizzle melted white chocolate over dried cookies. Let dry completely before storing, about 1 hour more.

CHOCOLATE-COVERED OREOS® FOR VALENTINE'S DAY

Steps:

• Place candy melts in a microwave-safe bowl. Microwave for 1 minute. Stir. Microwave for 30 seconds more. Stir. Repeat process until candy melts are completely liquid.
• Dip sandwich cookies into the melted candy melts - feel free to coat only half of the cookie, or coat all sides. Place red cookies on a plate lined with wax paper.
• Decorate with assorted sprinkles. Allow to harden before removing to serve.

RAW THIN MINT, RAW PEPPERMINT PATTY, RAW MINTY “OREO” AND RAW CHOCOLATE COVERED MINT “OREOS”!

Steps:

• Chocolate Coating 1. Melt cacao butter and coconut oil in dehydrator (115 degrees) or carefully over hot water. 2. Whisk in cacao powder, agave and optional stevia. 3. Let sit unti it thickens slightly. Mint Filling 1. Place coconut in food processor and process until it is powdered. Do not over process or it will turn into coconut butter. 2. Add coconut oil, agave and peppermint. Pulse to combine. 3. Chill until it begins to set. If it gets hard, just warm to room temp again. Chocolate Wafer Cookies (makes 24) 1. Mix all ingredients together. 2. Roll into balls and press to flatten or press into whoopie pie mold. Chill. For the Raw Mint Patties: 1. Shape Mint filling into balls and flatten. Dip into chocolate sauce and let harden. For the Mint "Oreos" (and chocolate dipped "Oreos"): 1. Roll Mint filling into ball, press flat, place between 2 chocolate wafers. 2. Dip in Chocolate Coating if desired. For the Raw Thin Mints: 1. Dip chocolate wafer in chocolate. Let set cool and up.

CHOCOLATE COVERED OREOS

Steps:

• melt chocolate in a double-boiler, leave on low heat.
• dip each cookie in chocolate, place on wax paper-lined cookie sheet (or plate).
• let cool in fridge until hard.