Best Grandmas Pressure Cooker Pot Roast Recipes

EASY PRESSURE COOKER POT ROAST

Steps:

• Heat oil in a pressure cooker over medium-high heat. Brown roast on all sides in the hot oil; season with pepper, seasoned salt, and onion powder.
• Pour in beef broth and Worcestershire sauce, add the quartered onion, and seal the lid. Bring the cooker up to full pressure. Reduce heat to low, maintaining full pressure, and cook for 30 minutes.
• Use the quick-release method to lower the pressure. Mix in carrots and potatoes, seal the lid again, and return the pressure cooker to the heat. Bring the cooker up to full pressure and cook for an additional 15 minutes. Use the quick-release method again and transfer the roast and vegetables to a serving dish.

OLD-FASHIONED PRESSURE COOKER POT ROAST

Steps:

• Pat the roast dry with paper towels. Season both sides of the roast well with salt and pepper. Select Sauté and preheat the pressure cooking pot. When hot, add the vegetable oil. Add the three pieces of roast to the cooking pot so that they lay flat in the pot. Cook until the beef is browned and releases easily from the pot. Transfer to a plate.
• Add the onion to the cooking pot. Sauté for about 3 minutes until tender, stirring occasionally to scrape up any browned bits from the bottom of the pot. Stir in the 3 1/2 cups water and beef base or bouillon, tomato paste, and bay leaf. Return the roast and any accumulated juices to the pot. Lock the lid in place. Select High Pressure and 50 minutes cook time.
• When the cook time ends, turn off the pressure cooker. Let the pressure release naturally for 10 minutes and finish with a quick pressure release. When the valve drops, carefully remove the lid. Transfer the roast to a cutting board and cover with aluminum foil.
• If you wish to cook potatoes and carrots with this meal, proceed with steps 4-6. Otherwise, skip to step 7: Add potatoes and carrots directly to the juices remaining in the cooking pot. Lock the lid in place. Select High Pressure and 3 minutes cook time.
• When the cook time ends, turn off the pressure cooker. Use a quick pressure release. When the valve drops, carefully remove the lid. Check the potatoes for doneness. If needed, select Sauté and simmer in the juices until potatoes reach your desired tenderness.
• Use a slotted spoon to transfer the potatoes and carrots to a serving bowl and sprinkle with parsley. Cover with foil until ready to serve.
• Pour the juices in the cooking pot through a mesh strainer into a fat separator. (You can skip the strainer if you like onions in your gravy. Be sure to remove the bay leaf, though!) Skim off any excess fat. Return the juices to the cooking pot.
• In a small bowl, whisk together the flour and 1/4 cup cold water until smooth. Add ½ cup hot cooking juices to the flour mixture and stir to combine. Add the slurry to the pot, stirring constantly. Select Sauté and bring the gravy to a boil, stirring constantly until it thickens. Taste the gravy and season with salt and pepper to taste.
• To serve, cut the roast into pieces and place on a rimmed serving platter. Ladle half the gravy over the roast and pour the rest of the gravy into a gravy boat to serve with the potatoes and carrots.

PERFECT PRESSURE COOKER POT ROAST

Steps:

• Heat oil in the pressure cooker over medium-high heat with the lid open. Brown the meat on al sides in the hot oil.
• In a small bowl, mix together the Italian and Ranch salad dressings and the gravy mix. Sprinkle them evenly over the roast. Pour in the beef broth and add the chopped onion.
• Seal and lock pressure cooker and cook over high heat to build pressure until the indicator sounds. Turn heat down to medium and cook for 45 minutes. Remove from heat and let stand for 5 minutes. Run under cold water to help release the pressure before unsealing the lid. You can use the juices as an au jus, or thicken with flour or cornstarch to make a yummy gravy.

OLD-FASHIONED POT ROAST

Steps:

• If desired, make 3/4-inch-deep, evenly distributed incisions in roast and push one slice of garlic into each.
• In 6-quart pressure cooker, heat 3 tablespoons oil over high heat. Add meat and brown well on all sides lifting meat frequently with spatula to prevent sticking-about 2 to 3 minutes per side. Add extra oil as needed. Season each browned side with salt and pepper, be conservative if you're using canned stock or bouillon. Remove meat to platter and set aside.
• In blackened oil remaining in cooker, sauté the chopped onion, carrot, celery, and parsnip for 3 minutes, stirring occasionally, scrape any browned bits from bottom of cooker. Add beef stock, bay leaves, and dried thyme.
• Set rack or trivet in cooker and place meat on it, broad side down, so that as much surface as possible submerges.
• Lock lid into place, heat to high pressure over high heat. Reduce heat to just enough to maintain high pressure and cook 60 minutes. Let pressure drop naturally for 15 minutes (see " Releasing Pressure"). Remove lid, opening it away from you, to allow any remaining steam to escape.
• When pot roast is done, it should be easy to pierce with a fork. If it is not sufficiently tender, lock lid back in place and heat to high pressure for another 5 minutes, let pressure drop naturally.
• When roast is fork-tender, transfer to platter, set aside in warm place. Remove rack from cooker. Place potatoes, whole onions, and parsnip chunks in cooker. Lock lid into place and return to high pressure over high heat. Reduce heat to just enough to maintain high pressure and cook 5 minutes.
• Meanwhile, slice meat. Reduce pressure in cooker using quick-release (see " Releasing Pressure"). Remove lid, opening it away from you, to allow any remaining steam to escape. With slotted spoon, transfer vegetables to platter around meat, set aside in warm place.
• Over high heat, gradually whisk flour-butter mixture into liquid in cooker. Cook, stirring constantly, until mixture thickens-3 to 4 minutes. Remove bay leaves and season to taste. Pour gravy over meat and vegetables on platter, sprinkle with fresh thyme, if desired, and serve immediately.

JEN'S PRESSURE COOKER POT ROAST RECIPE - (4.5/5)

Steps:

• Season roast with salt and pepper on all sides; coat roast with flour (reserve leftover flour for gravy). Melt shortening in a pressure cooker over medium-high heat. Brown roast on all sides in hot shortening. Sprinkle onion soup mix over the roast. Pour in at least two cups of water; use 1 to 2 cups more if the beef is a tough cut or to reach the minimum amount recommended by the pressure cooker's manufacturer. Seal the lid and bring the cooker up to full pressure over high heat. Reduce the heat to low, maintaining full pressure, and cook for 1 1/2 to 2 hours. Release the pressure and test for doneness; the meat should be fork-tender. Add potatoes and onions, making sure the vegetables are submerged in the cooking liquid. (You may need to rearrange the roast on top of the vegetables or add more water.) Seal the lid and return the pressure cooker to full pressure. Reduce heat to low, maintaining full pressure, and cook for 10 minutes. Release the pressure; transfer meat and vegetables to a serving platter. To make gravy, bring the cooking liquid to a boil. Whisk reserved flour into 1/2 cup cold water; whisk the flour mixture into the boiling broth. Cook until thickened, stirring occasionally, about 3 minutes. Serve gravy with pot roast and vegetables.